This website is made to explain to you about the Cas Interface. As you can read in the forums there are lot of questions about the Cas Interface and we want to help you to program with the Cas Interface. Offcourse our visitors are welcome to send e-mail  enquiries and news about the Cas Interface As  I always say two know more then one.

Beware >>>  You can't find free files here to watch encrypted pay television. E-mails about this subject will not be anwsered. The  purpose of this website is to exchange information and software programs for programming with the Cas Interface.

 

Your Magic Module as Matrix Reload with the CAS INTERFACE

You need this software for make Matrix Reload cam from your Magic Module:

Cas studio 2.1
Matrix.cas
MR 1.01, 1.02 or MR1.03.bin

 

Installing the Cas Interface

 So first install the card with the programmer you can do this with the Flat cable 
So put  the plug  from the adapter in the programmer beware the adapter must
standing on 9 volt 12 volt is also not a problem because the interface haves a regulator what brings the 12 volt back to 9 volt. Connect now the parallel cable with the interface and on the printerpoort of your computer.

Put the card in the module Module


On the right side you see  the card which is connected with the interface, put this card in the magic module or clone with the connectors up when you have do this you can open the program CAS Studio 2.1


Open the program CAS studio 2.1 


Connect Module

 Click on the button CONNECT  
AWhen thats ok you see the infomation from your cam in the program



You got only wrong reports look then even on the Faq page or the forum

 Erase the card

Before drop a new flash on the cam yoy must erase the old flash
Click now on the button  ERASE ALL

In the picture above you see Right below (counter) how far the erase are the number of blocks incur and count as from 0 and then further

Loading the XILINX file 

After the Erase procedure are last can you now loading the XILINX file  
Click below by XILINX Functions on WRITE 
And select now the file MATRIX.CAS

When you have select the good loader click on  OPEN
The proces is beginning now and the during time is short

Now we going load the Matrix Reload file

Click now on OPEN FILE you see the next screen select the 
Matrix reload file you want  you can find all this files in the Download section

When you have select the good Matrix Reload file click on  OPEN

Write the Matrix Reload file

You can now click on WRITE the proces is beginning
There is a blue line what you let see how far the programming is
You can also look to the counter on the right side 

 

Your module is now a Matrix Reload

When you get this box on the screen with  Device Programmed and verified succesfully
than is the module ready and works it same as the Matrix Reload


 

  

CAS Interface     Programming    Software     Forum    Faq    Receivers    Links    E-mail

Webdesign Magic Trance Augustus 2003